Application of high fastness nylon thick board slurry and waterborne three-dimensional thick board slurry

Suitable for clothing printing, handbag bottom printing, webbing printing, shoe upper printing, etc. It has the characteristics of good fastness, good thickness, soft hand feeling, non-adhesive, strong three-dimensional feeling and so on.
Appearance: 6020C is slightly yellowish, 6020 is pure white;
1. Formula: It is made by mixing imported PU resin and additives;
2. Viscosity: 145000~155000cps;
3. Ionicity: non-ionic;
4. Storage period: 6 months (normal temperature, sealed).
2. Application: Apply
1. This product needs to be used with 1%-2% of the auxiliary agent.
2. This product generally uses 80-mesh and 120-mesh screens. The screens must be tightened according to different patterns, which is quite critical.
3. This product is not easy to clog the net. When it is too thick, add an appropriate amount of water slurry and stir evenly for dilution;
4. This product is easy to operate. In order to ensure the printing effect, it is generally recommended to directly use the flat screen (normal screen) without making thick plates; the ordinary screen prints 1 mm high as long as 6-8 times, and the screen is hardened around it. The height of the object should be about 1-1.5mm between the screen and the table. When using thick screen printing, after the first printing, it must be dried before the second printing;
5. After natural air drying for 48 hours, the temperature is about 100 degrees/8-15 seconds. When the temperature is too high, try to pass the fabric over the reverse side (the specific temperature should be adjusted according to the temperature resistance of the fabric). After overheating, it can withstand 60° washing water,